In-dash 11.3" monitor.
I would really appreciate it if everyone visiting this page would leave me some feedback. Please post your feedback by clicking here.
This monitor is located where the factory radio used to be...( i know i know......the radio is being relocated). As most of you know this is what the car's dash looks like from the factory.
I originally installed a 10.4" monitor but I upgraded to an 11.3". The controller board for the 10.4 crapped out during testing and i got a good deal on a 11.3" lcd monitor. So its was back to the drawing board.
Well this first picture is whats
left of the pretty monitor i purchased.
I got a replacement panel to start fabrication. I already have the monitor. So i cut the panel then test fitted the monitor.
I used the actual frame from the monitor housing. Otherwise the rest of the fabrication is the same. I also integrated the monitor control switches into the bezel as shown in these pictures. The fabrication of the control switches is the same as all other fabrication. However only bond was used in this case. No fiber glass.
And the completed piece.
Bookmark this Ride